Differences

This shows you the differences between two versions of the page.

--- hardware:robotnik_rb-1 [2019/07/23 08:57] – [ATTENTION] ppapadakis
+++ hardware:robotnik_rb-1 [2020/01/17 09:56] (current) – [Uses] ppapadakis
@@ Line 48: / Line 48: @@
 A complete software documentation is provided {{ :hardware:rb-1-software.doc.pdf |}} with some annotations on the .pdf.
-ATTENTION
+**ATTENTION**
 The robot does not currently have a mechanism to safely 'park' the Kinova arm before the robot is switched off. As a result, once the robot is switched off, the arm will start falling under the influence of gravity, potentially damaging itself or anything along its path. The fall of the arm can be prevented either by teleoperating it to a safe (stable) position, or by holding it and gently moving it to a safe position **after** having it switched off.
@@ Line 57: / Line 58: @@
 If possible, add internal links to the project description page (or integrate them as shown in the best practice page).
+**Repairing of detached finger(s) of robotic arm**
+The fingers of the grippers have been designed so that if excessive force is applied on them, they do not get broken but instead they get "detached" from their tendons. To put back into place the detached fingers, one has to delicately reattach the fingers to their tendons. The instructions provided by an e-mail of the ROBOTNIK constructor are as follows:
+//Our support team told us the following advice: We have to insert the cotter pin into the holes (As the picture shows)//
+{{:hardware:image.png|}}
+//Shiftiness steps:
+. Close the robotic hand
+. Pull carefully the disabled finger
+. Gently with caution, with a little screwdriver, strip the part (green coloured)
+. Insert one by one the cotter pin into the holes (as the blue arrow shows)
+//
 ===== External links =====