Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
obstacle_detection [2016/03/13 08:57] zyuan |
obstacle_detection [2016/03/13 08:59] zyuan |
||
|---|---|---|---|
| Line 4: | Line 4: | ||
| Calibration Parameters for the calculation of 3D coordinates from the raw image measurements include: | Calibration Parameters for the calculation of 3D coordinates from the raw image measurements include: | ||
| - | The height of Kinect. (In addition, we found that y-axis of the point cloud corresponds to the height, means the z-axis for a tf-tranform of Kinect Sensor) | + | The height of Kinect. |
| + | |||
| + | (In addition, we found that y-axis of the point cloud corresponds to the height, means the z-axis for a tf-tranform of Kinect Sensor) | ||
| You can simulate the result by using rviz: | You can simulate the result by using rviz: | ||
| //rosrun rviz rviz// | //rosrun rviz rviz// | ||
| + | |||
| Choose the output topic "output" in type of "PointCloud2" | Choose the output topic "output" in type of "PointCloud2" | ||
| - | TODO: add FindingBlob to optimize the results. | ||
| The package: {{:pcl_detector.tar.gz|}} | The package: {{:pcl_detector.tar.gz|}} | ||
| - | To use it: | ||
| 1. Launch Kinect Sensor | 1. Launch Kinect Sensor | ||
| * //roslaunch openni_launch openni.launch// | * //roslaunch openni_launch openni.launch// | ||
| 2. Run | 2. Run | ||
| * //rosrun pcl_detector pcl_detector// | * //rosrun pcl_detector pcl_detector// | ||