Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
obstacle_detection [2016/03/13 08:54] zyuan |
obstacle_detection [2016/03/13 08:59] zyuan |
||
---|---|---|---|
Line 4: | Line 4: | ||
Calibration Parameters for the calculation of 3D coordinates from the raw image measurements include: | Calibration Parameters for the calculation of 3D coordinates from the raw image measurements include: | ||
+ | The height of Kinect. | ||
+ | |||
+ | (In addition, we found that y-axis of the point cloud corresponds to the height, means the z-axis for a tf-tranform of Kinect Sensor) | ||
- | The height of Kinect. (In addition, we found that y-axis of the point cloud corresponds to the height, means the z-axis for a tf-tranform of Kinect Sensor) | ||
You can simulate the result by using rviz: | You can simulate the result by using rviz: | ||
+ | //rosrun rviz rviz// | ||
- | $rosrun rviz rviz | ||
Choose the output topic "output" in type of "PointCloud2" | Choose the output topic "output" in type of "PointCloud2" | ||
- | TODO: add FindingBlob to optimize the results. | ||
The package: {{:pcl_detector.tar.gz|}} | The package: {{:pcl_detector.tar.gz|}} | ||
- | To use it: | ||
1. Launch Kinect Sensor | 1. Launch Kinect Sensor | ||
- | $roslaunch openni_launch openni.launch | + | * //roslaunch openni_launch openni.launch// |
2. Run | 2. Run | ||
- | $rosrun pcl_detector pcl_detector | + | * //rosrun pcl_detector pcl_detector// |