Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
hardware:rb1_quickstart [2021/02/12 13:56] cedric.lb [From a remote computer] |
hardware:rb1_quickstart [2021/02/12 14:25] (current) cedric.lb [Controlling the kinova-arm only] |
||
---|---|---|---|
Line 72: | Line 72: | ||
rb1@rb1:~$ roslaunch rb1_jaco_3fg_moveit_config demo_rtc.launch | rb1@rb1:~$ roslaunch rb1_jaco_3fg_moveit_config demo_rtc.launch | ||
- | This will open rviz and moveit. | + | This will open rviz and moveit. In Motion Planning > Planning Request > Planning Group, select 'rb1_arm'. By default, it is on 'gripper' and they cannot be controlled via the moveit interface. |
+ | |||
+ | {{hardware:rb1_real_moveit_indigo_arm.png?500}} | ||
- | Select the rb1_arm and move the arm around, plan and execute. | + | The arm can now be moved as wanted. |
+ | {{hardware:rb1_real_moveit_rviz.png?500}} | ||
==== From a remote computer ==== | ==== From a remote computer ==== | ||
Line 124: | Line 127: | ||
This will start rviz and moveit and allow control of the arm. | This will start rviz and moveit and allow control of the arm. | ||
+ | |||
+ | {{hardware:kinova_rviz.png?500}} | ||
| | ||
More further information and additional launchfiles: {{ https://github.com/Kinovarobotics/kinova-ros/wiki/MoveIt }} | More further information and additional launchfiles: {{ https://github.com/Kinovarobotics/kinova-ros/wiki/MoveIt }} |